HCigar Nemesis Mod Brass

The main tube on the HCigar Brass Nemesis Mod features the famous Nemesis logo laser engraved on the mod's 100% Brass body. And like any exclusive mod, each one of the HCigar Brass Nemesis mods has an individualized serial number laser engraved on the mods 18350 tube. The HCigar Brass Nemesis mod comes with 3 battery tubes allowing you to easily change the length of your mod and use different sized batteries without having to purchase anything additional. The HCigar Brass Nemesis mod gives you the ability to use the mod in 18350, 18500 and 18650 mod. The bottom button of the HCigar Two Tone Nemesis mod has an exquisite switch that easily fires as it was ergonomically designed to sit comfortably in your hand. The firing button is located at the bottom and has a locking feature that can be collapsed by tightening the locking ring all the way down. The top cap airflow ring allows for adjustable air flow which is crucial for people who are not using rebuildable atomizers on their HCigar Nemesis mod.

Facts and Features;

• 100% Brass No Circuit Board (True Mechanical Mod)
• Laser Etched Engraving and Logo Laser Etched Engraved Individual Serial Number
• Silver-Plated Firing Pin
• Adjustable Silver-Plated Atomizer Contact Pin
• Bottom Firing Button with Locking Feature
• Adjustable Air Flow Control Ring
• 3 Nemesis Tubes for 18350, 18500, and 18650 Batteries
• Batteries Sold Separately
• 510 Atomizer Connection

General Tips Always Insert the Positive Side of the Battery into the tube FIRST! So if your mod was sitting on a table, the positive side of the battery would be facing up and the negative side of the battery should be facing down towards the button (Just like any mod, failing to properly insert your battery will kill your mod) Most customers have found that if you are not running a kick chip, removing the Beauty Ring allows the button to fire easier. Only remove the kick beauty ring if you are using protected batteries.

Prior to using your Nemesis mod, we suggest cleaning the contact pin, firing pin, tube threads, as well as the inside of all of the tubes. To clean simply remove the contact pin from the mod and thoroughly clean the contact pin, firing pin, threads, and inside of the mod tubes with a microfiber towel and standard rubbing alcohol to remove the manufacturing oil which will decrease the conductivity (aka decrease the resistance/drop voltage)

Please Note Nemesis Copper Contact Kit Add-On Includes 2-pieces; 1 copper atomizer contact and 1 copper button contact. To install the Nemesis Copper Contact Kit, simply remove (by unscrewing) the included silver-plated contacts and screw in the Copper Contacts. This process usually takes about 15 seconds.